Saving, Retrieving And Deleting Results; Cleaning And Storing The Instrument - Beurer BM 16 Gebrauchsanweisung

sure as well as the value above which your blood pressure is
classified as dangerous.
The bar graph in the display and the scale on the unit indicate
the range of the blood pressure which has been recorded.
If the values for systolic and diastolic pressure are in two dif­
ferent ranges (e.g. systolic in the high­normal range and dias­
tolic pressure in the normal range) the graphic classification on
the unit indicates the higher range (high­normal in the example
described).
Table for classification of blood pressure values (unit of
measurement mmHg) for adults:
Range Systolic
Normal range 105 – 119 60 – 79
Pre-hypertensive 120 – 139 80 – 89
blood pressure
range*
High blood pres- 140 – 159 90 – 99
sure - degree
High blood pres- ≥ 160
sure - degree
(*) Blood pressure range that might transfer to high blood pressure

6. Saving, retrieving and deleting results

The computer automatically saves the blood pressure readings
of the last 50 measurements. When the 50 memory locations
are exceeded, the current oldest value is deleted.
You can display the memory as follows:
Diastolic Action
Self check
Check with doctor
Consult your
doctor
≥ 100 Consult your
doctor
Adapted from JNC 2003
• Press the user selection button
zone, and press the M key to switch from memory to mem­
ory with sequence numbers.
• The saved measured values are continuously stored.
• Press the On/Off switch
• If you forget to switch off the computer, it will switch off auto­
matically after 1 minute.
Press the user selection button
zone, then press and hold the M key for approximately 5­sec­
onds to clear the data in the pre­designated memory zone.
The data in both memory zones – zone 1 and zone 2 may be
erased if any of the batteries is removed.

7. Cleaning and storing the instrument

• Clean your device and cuff carefully only with a slightly mois­
tened cloth.
• Do not use detergents or solvents.
• On no account must you immerse the computer in water,
otherwise liquid can enter it and cause demage.
• When storing the device, make sure that no heavy objects
are placed on top of it. Remove the batteries. The cuff tube
should not have any sharp kinks.
20
to select a memory
to turn the unit off.
to select a memory