Slave Mode; System Settings - Cameo S4 IP Bedienungsanleitung

EZ REMOTE CONTROL VIA CAMEO UNICON (optionally available)
Starting from the main display, press the left push button rotary encoder to access the menu for
selecting the mode. Turn the left encoder (SELECT) to choose EZ Remote (see left arrow) and
confirm by pressing the left encoder (ENTER). Now set the desired device ID (Fixture ID 1 – 8) by
turning the left encoder (SELECT) and confirm by pressing the left encoder (ENTER).
Connect the spotlight and UNICON using a DMX cable, select DMX Control in the UNICON menu,
then EZ Remote, and enter the same unit ID. Now control the spotlight using RGB, GEL, CCT or
HSI. By assigning different unit IDs, up to eight spotlights (or spotlight groups) can be controlled
separately via UNICON.

SLAVE MODE

Starting from the main display, press the left push button rotary encoder to access the menu for
selecting the mode. Turn the left encoder (SELECT) to choose Slave (as indicated by selector
arrow on left) and confirm by pressing the left encoder (ENTER). Connect the slave and master
unit (same model, same software version) using a DMX cable, and activate one of the stand-
alone modes on the master unit. The slave unit will now follow the master unit. Alternatively, the
control signal can be transmitted via W-DMX. Activate W-DMX in both the master and slave unit.
Configure the master unit as transmitter, the slave unit as receiver and pair the devices (Settings
-> Wireless Settings).

SYSTEM SETTINGS

Starting from the main display, press the right push button rotary encoder to access the menu for
selecting the mode (menu). Turn the left encoder (SELECT) to choose Settings (see left arrow)
and confirm by pressing the left encoder (ENTER).
This will take you to the submenu for setting the submenu items (see table, select by turning the
left encoder , confirm with ENTER, change value or status by turning the left encoder, confirm
with ENTER).
26