Herunterladen Inhalt Inhalt Diese Seite drucken

Slave Mode - Cameo PIXBAR G2 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für PIXBAR G2:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 41

SLAVE MODE

Standard slave operation: Starting from the main display, press MENU to enter the main menu.
Using the UP and DOWN buttons, you now select the menu itemSlave confirm with ENTER, select
the Slave Group 0 and confirm again with ENTER. Connect the slave and master units (same mo-
del, same software version) using a DMX cable or W-DMX™ and activate one of the stand-alone
modes (Direct LED, Color Preset, CCT, HSI, Auto Program, Play Loop) in the master unit. The slave
unit will now follow the master unit.
Extended slave operation: If you want to control the slave units by one of the stand-alone
modes Auto Program or Play Loop in master / slave operation, the control signal can be played
back with a time delay of up to 24 steps, the delay is set in the Stand Alone menu Master/Alo-
ne in the master unit, the delay factor in the slave menu of the corresponding fixture (Group). This
is a simple way to create a running light effect with a large number of spotlights that are all the
same model and have the same software version. This is otherwise only possible using a suitable
DMX controller and time-consuming programming. Connect the slave and master units (same
model, same software version) using a DMX cable or via W-DMX
Assign the spotlights to one of up to 24 groups (plus Group 0) according to preference, whereby
several spotlights can be assigned to one group. The group number is also the factor by which the
delay time set in the master unit is multiplied.
Setup example:
22
Set slave group for signal delay
Activate W-DMX
module
Deactivate W-DMX
module
Disconnect all con-
nections and place in
pairing standby mode

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Clpb400ipg2Clpb600ipg2

Inhaltsverzeichnis