Main Display In The Artnet Or Sacn Mode - Cameo S4 IP Bedienungsanleitung

MAIN DISPLAY IN THE ARTNET OR SACN MODE

The main display in ArtNet or sACN mode shows the DMX mode, the currently set DMX start
address, the IP address and universe group and the universe (see illustration).
DMX start address
Universe and Group
Press encoder =
Mode selection
W-DMX™
To pair a W-DMX receiver with a W-DMX-compatible transmitter, W-DMX must be switched on
in the receiver's settings menu under Wireless Settings (WDMX State -> On), the device must
be configured as a receiver (Operating Mode -> Receive) and the Reset command must be
executed (Receive Reset -> Yes). The receiver is now in pairing standby and waiting for a pairing
request from a transmitter. Start the pairing by selecting Link in the menu of the transmitter and
confirming; the pairing now takes place automatically. In the same way, several receivers can be
paired simultaneously or one after the other to a transmitter (e.g. for master / slave operation).
A W-DMX connection is always maintained until the connection is disconnected by means of the
Reset command in the receiver or the Unlink command in the transmitter, regardless of whether a
device has been disconnected from the power supply in the meantime.
W-DMX W-DMX
as receiver
deactivated
activated,
not paired
Currently activated operating mode
DMX mode
IP address
W-DMX W-DMX
as receiver as receiver as receiver
activated activated
and and
paired, paired,
Transmitter no DMX signal
switched off DMX signal is present
or out of
range
W-DMX status
Press encoder =
Open the main menu (Menu)
W-DMX W-DMX W-DMX
as trans- as trans-
activated mitter
and with G3 with G4s
paired, standard standard
activated, activated,
DMX signal
DMX signal
is present is present
W-DMX W-DMX
as trans- as trans-
mitter mitter
with G3 with G4s
standard standard
activated, activated,
no
DMX signal DMX signal
mitter
no
17