Slave Mode - Cameo F2 D IP Bedienungsanleitung

SLAVE MODE

Press the encoder to access the main menu. Rotate the encoder to select the menu item Slave
(left arrow) and confirm by pushing the encoder. Slave mode is now enabled, and the main display
is automatically displayed. Connect the slave and the master units (same model) with a DMX
cable and enable the standalone mode static on the master unit. The slave unit will now follow the
master unit.
-------------- Menu --------------

DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
DEVICE SETTINGS (Settings)
Press the encoder to access the main menu. Rotate the encoder to select the menu item Settings
(left arrow) and confirm by pushing the encoder. This will take you to the submenu for setting the
submenu items (see table, rotate the encoder to select and push the encoder to confirm selec-
tion). Now select the arrow symbol for back at the top of the submenu. Push the encoder and ac-
cess the main menu in the same way to return to the main display. The main display is activated
automatically if no input is made within approximately 30 seconds.
-------------- Menu --------------

DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
Settings
Display = Rotate
Reverse display
Display Off = Display
lighting
16
Mode
Slave
Back
On Display is rotated by 180° (e.g. for overhead
installation)
Off No display rotation
Back
On on permanently
Off Deactivation after approximately 1 minute of
inactivity