Auto Mode; Slave Mode - Cameo FLAT PRO INDOOR PAR CAN Bedienungsanleitung

OPERATION:
COLOUR BLENDING
In the colour fade mode (fading mode) different colours are blended into one
another in succession. The speed of the program is adjustable separately and
a stroboscope effect can also be activated.
Press the MODE button until "FADING" appears in the upper line of the
display. Now, press ENTER until the cursor appears in the lower line of the
display, and then select the rate (SPEED) using the UP and DOWN buttons,
with the colours alternating from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display
changes to "FLASH:xx". The cursor will appear in the bottom line at the
same time and you can activate the stroboscope effect using the UP and
DOWN buttons and adjust the flash frequency from 00 to 99 (FLASH:00 =
strobe deactivated, FLASH: 01 = approx. 1 Hz, FLASH: 99 = approx. 20 Hz).
Confirm with ENTER.
COLOUR BLENDING
Rate SPEED:00 - SPEED:99
STROBOSCOPE
Flash frequency FLASH:00 - FLASH:99

AUTO MODE

Press the MODE button repeatedly until "AUTO MODE" appears on the
display. In this operating mode, the light switches automatically between
colour change and colour blending mode. The colour change and/or colour
blending rate is determined by the settings of the respective mode. A
stroboscopic effect cannot be activated.

SLAVE MODE

Press the MODE button repeatedly until "SLAVE MODE" appears on the
display. Connect the slave and the master unit (same series) with a DMX
cable. Now the slave unit follows the master unit.
12