Timer Function; Slave Mode - Cameo X3 D Bedienungsanleitung

TIMER FUNCTION

The timer function allows the standalone mode Static to be timer controlled in such a way that
the fade-in time can be set from 0 to 60 minutes, the dwell time from 1 to 24 hours and the
fade-out time from 0 to 60 minutes. Time control starts immediately after activating the timer
function in the previously activated standalone mode and remains active even if the spotlight is
switched off and restarted.
Starting from the main display, press the encoder to enter the main menu. Select the Stand
Alonemenu item, confirm, then select Timer and confirm again. Now select Fade In, Dwell Time
or Fade Out for the individual settings and confirm. A number field is shown in the display in each
case and you can set the value as desired from 1 to 60 or 1 to 24 by turning the encoder. Confirm
again. Once all settings have been made as desired, activate the timer function by selecting the
Timer On/Off sub-menu item, confirm, select On and confirm again (to deactivate the timer func-
tion, please select Off and confirm).
Note: The timer function is suitable for use in master/slave operation via cable.

SLAVE MODE

Starting from the main display, press the encoder to enter the main menu. Select the Slave
menu item and confirm the selection. Connect the slave and the master unit (same model, same
software version) using a DMX cable and activate one of the stand-alone modes (Static, Auto) in
the master unit. The slave unit will now follow the master unit.
16