Slave Mode - Cameo NANOBEAM 600 Bedienungsanleitung

ACTIVATING SOUND CONTROL
Select one of the auto programmes as previously described under "CONFIGURING AUTO MODE". Using the UP and DOWN buttons, select the
menu item "Sound Mode" (coloured background) and confirm with ENTER, then use UP and DOWN once again to select "On" and confirm
with ENTER. You can set the microphone sensitivity by selecting the menu item "Sound Sens" using the UP and DOWN buttons, confirming
with ENTER and then using UP and DOWN once again to select a value between 00 and 99 (hold button down to change values quickly, 00
= minimum and 99 = maximum sensitivity). Confirm the entry with ENTER and press MENU twice to return to the main display. After about
1 minute of inactivity, the main display is automatically activated and the mode is clearly shown in the centre of the display. The spotlight
will now be controlled via the built-in microphone and will follow the rhythm of the music (bass signals).

SLAVE MODE

Press MENU to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item "Slave Mode"
(coloured background) and confirm with ENTER. Press MENU to return to the main display. After approx. one minute of no input, the main
display is automatically activated and SLAVE is shown clearly at the centre of the display. Connect the slave and the master units (same
model, same software version) with a DMX cable and enable one of the standalone modes (Auto, Sound) on the master unit. The slave unit
will now follow the master unit.
ADVANCED SETTINGS
Press MENU to access the selection menu (System Settings). Using the UP and DOWN controls, select the menu item "Advanced Settings"
(coloured background) and confirm with ENTER. This will take you to the submenu for editing the following submenu items (selection with
UP and DOWN, confirm with ENTER, change status with UP and DOWN, confirm with ENTER):
Advanced Settings
Reset = Reset motors
Pan invert = Pan direction
Tilt invert = Tilt direction
Yes Resets the pan & tilt motors
No Cancel reset of pan & tilt motors
No Does not reverse pan direction
Yes Reverses pan direction
No Does not reverse tilt direction
Yes Reverses tilt direction
7