Cameo S4 IP Bedienungsanleitung Seite 29

Colour = Colour
Calibration calibration
(cross-mode)
Autolock = Automatic
locking of the
controls
Fan = Fan control
RAW R, G, B and W with maximum value 255
User Individual colour calibration. Cross-mode
Calibration brightness setting of R, G, B and W with values
from 0 – 255. Set
R and G with the middle and right encoder,
then press the middle encoder (Next Colours)
and set B and W again with the middle and
right encoder.
Factory Factory calibration of R, G, B and W
Calibration
Smart Merging factory and RAW calibration
Calibration
On Automatic locking of the controls after
approximately 1 minute of inactivity. Display
shown upon attempted use: "Locked!"
Unlock: Simultaneously press the centre and
right encoders for approx. 5 sec.
Off Automatic locking of the controls is disabled
Auto Automatic fan speed control
Off Deactivated fan with greatly reduced
brightness
Constant Constantly low fan speed with reduced
Low brightness, if necessary
Constant Constant average fan speed with reduced
Medium brightness, if necessary
Constant Constant high fan speed
High
29