SLAVE MODE
Starting from the main display, press the left-hand rotary-push encoder to access the menu for
selecting the operating mode. Turn the left encoder to select the Slave menu item (note the selec-
tion arrow on the left) and confirm by pressing the encoder (ENTER). Slave mode is now enabled,
and the main display is automatically displayed. Connect the slave unit and the master unit (same
model, same software version) using a DMX cable and activate one of the standalone operating
modes in the master unit. The slave unit will now follow the master unit.
currently activated operating mode
Press encoder =
Selection of the operating mode
(Mode)
DMX OPERATION
Starting from the main display, press the left-hand rotary-push encoder to access the menu for
selecting the operating mode. Turn the left encoder to select the menu item DMX (note the selec-
tion arrow on the left) and confirm by pressing the encoder (ENTER). DMX mode is now activated
and the main display is automatically shown again. Select one of the ten available DMX modes in
the DMX Mode menu item in the main menu (see SET DMX MODE).
DEVICE SETTINGS (Settings)
Starting from the main display, press the rotary-push encoder to enter the main menu. Turn the
left encoder (SELECT) to select the Settings menu item (note the selection arrow on the left)
and confirm by pressing the left encoder (ENTER). This takes you to the submenu for setting the
submenu items (see table, select with SELECT, confirm with ENTER, change value or status with
SELECT, confirm with ENTER ).
20
Fan mode
Press encoder =
Open main menu (Menu)