Cameo S4 IP Bedienungsanleitung Seite 19

Protocol ArtNet and sACN
Select by turning the left encoder, confirm by pressing, change value or status by turning,
confirm by pressing. Back with ESC.
Universe Setting the universe
Universe Group Setting the Universe Group
DMX Address Setting the DMX start address
DMX Mode Selecting the DMX mode
IP Address Setting the IP address:
1. Set block with middle encoder
2. Set block with right encoder
Press middle encoder (Next Range)
3. Set block with middle encoder
4. Set block with right encoder
Press left encoder to save (Enter)
Subnet Mask Setting the subnet mask:
1. Set block with middle encoder
2. Set block with right encoder
Press middle encoder (Next Range)
3. Set block with middle encoder
4. Set block with right encoder
Press left encoder to save (Enter)
Signal routing Forwarding the control signal via XLR Out
Forwarding the control signal via W-DMX
Forwarding the control signal via XLR Out and
W-DMX
Actuation via XLR with ArtNet or sACN signal
interruption
000–255
000 – 127
001–512
1CH dim ... 32CH
pixel
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
Send to XLR
Send to WDMX
Send to both
Backup by XLR
19