Main Display; Dmx Address; Battery Charge Status In Standby Mode - Cameo ZENIT B200 Bedienungsanleitung

MAIN DISPLAY

After the power-up process, the lamp is ready for operation and starts in the previously activated mode. The main display appears with the
following information: current mode (e.g. DMX mode), W-DMX™ status, battery charge status and mains operation.
W-DMX™ status Battery charge status
Mains operation

DMX Address

001
Current operating mode

BATTERY CHARGE STATUS IN STANDBY MODE

To recharge the internal battery, connect the lamp to the mains with the supplied power cable. The battery charge status is indicated by the
battery symbol on the display.
W-DMX™
1. To pair with W-DMX™ compatible transmitters, enable W-DMX™ in the device settings (Settings -> Wireless Setting -> W-DMX On Off
-> On) and reset the W-DMX™ module (Receive Reset -> Yes). Start the pairing process as described in the operating instructions of the
W-DMX™ transmitter. Pairing is then completed automatically.
2. Connect a group of W-DMX™ devices to create a DMX universe. Disconnect all devices that are supposed to form the group (Settings
-> Wireless Setting -> Receive Reset). Now activate a CLZB200 with a DMX controller via DMX cable and in the settings, select "Transmit"
(Send) (Settings -> Wireless Setting -> Operating Mode -> Transmit). In the settings of the W-DMX™ devices to be controlled via W-DMX™,
select "Receive" (Settings -> Wireless Setting -> Operating Mode -> Receive), pair them and confirm by selecting "Link" (Settings ->
Wireless Setting -> Link -> Link) in the settings of the CLZB200 controlled via DMX cable. Pairing is then completed automatically.
3. It is also possible to create a networked group of W-DMX™ devices via W-DMX™ and to operate them in master/slave mode to use.
Disconnect all devices that are supposed to form the group (Settings -> Wireless Setting -> Receive Reset). Now, in the settings (Settings
-> Wireless Setting -> Operating Mode) of the master unit select "Transmit" (send) and in the settings of the selected slave units, select
"Receive". In the master unit, select the entry "Link" (Settings -> Wireless Setting -> Link -> Link) and confirm by pressing ENTER. Pairing
of the devices is then completed automatically. In the master unit, select one of the standalone modes (Auto, Colour Macro, Static, Tunable
White, User Colour) and control the slave units with it.
8