Assemble/Set Workpiece Supports; Screw Device On To Workbench; Operation; Switching On And Off - Parkside PDOS 200 C2 Originalbetriebsanleitung

GB IE NI
Assemble/set
workpiece supports
1. Screw the workpiece supports (11) on
to the device.
To do this, use the screw (12a), washer
(12b), toothed washer (12c) and star
nut (12) supplied.
2. Set the workpiece support (11) of the
grinding disc with the star grip nut
(12): The distance between the grind-
ing disc (10) and spark protection must
not exceed 2 mm (see small image).
Periodically readjust the workpiece
support in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
Screw device on to
workbench
Screw the device onto the workbench with
4 screws and nuts.
Insert the screws through the 4 bore holes
(13) on the base of the device.
The screws and nuts required for as-
sembly are not part of the scope of
delivery.

Operation

Caution! Risk of injury!
- Always disconnect the plug from
the mains socket before working.
- Use only grinding discs and ac-
cessories recommended by the
manufacturer. The use of other
insertion tools and other acces-
sories may cause risk of injury.
- Only use grinding tools which
bear information about the manu-
12
CY
facturer, type of binding, dimen-
sion and permitted number of
revolutions.
- Only use grinding discs where
the printed rotational speed is at
least as high as what has been
specifi ed on the name plate of
the device.
- Do not use broken, cracked or
otherwise damaged grinding
discs.
- Never operate the device without
the visual protection disc.
- Always inspect the grinding disc
before starting the device:
Check the distance between the
spark protection and grinding
disc as well as workpiece support
and grinding disc (distance maxi-
mum 2 mm).
- The grinding disc must be re-
placed once the spark protec-
tion and workpiece support on
the grinding disc are no longer
spaced at 2 mm.
- Switch on the equipment only
when it is safely installed on the
work surface.
Keep your hands away from
the grinding disc when the
device is in operation. Injury
hazard!

Switching on and off

Ensure that the mains voltage
matches the specifi cations on the
rating plate.
Connect the equipment to the
mains.