Cuff Connection; Data Socket; Infrared Interface - IEM Mobil-O-Graph Gebrauchsanweisung

Cuff connection

The cuff connection is located on the front casing of the Mobil-O-Graph
connect the blood pressure monitor to the cuff via the cuff tube and the metal sleeve of the cuff.
ATTENTION
The metal plug (air coupling) must always engage with an audible "click". Otherwise there will be a leaky
connection between the Mobil-O-Graph

Data socket

The data socket is located on the left side of the casing (see Fig. 1). The connection cable provided is connected
to this socket. This is a plug connection; the red dot of the plug must be plugged onto the red dot of the socket.
Pull the outer metal ring to release the connection.
Further information can be found in the HMS CS instructions for use.

Infrared interface

The infrared interface provides an equivalent wireless alternative to the data socket. To use this interface, you need
the PC infrared interface IR-Med. The infrared interface can be obtained from your specialist supplier.
Further information can be found in the HMS CS instructions for use.
® and tube which will lead to measurement errors.
Product description
® (see Fig. 1). This metal plug is needed to
EN
25