Setting The Time/Date; Transferring Patient Data (Id) - IEM Mobil-O-Graph Gebrauchsanweisung

Product description

Setting the time/date

The Mobil-O-Graph ® has an internal backup battery which allows the time to continue even after removing the
power pack or batteries from the battery compartment. Nevertheless, the time and the date should be checked
before every measurement series.
The time and date can be set with the respective evaluation software.
You can set the time and date manually by holding down the start button and pressing the event button. Now you
are in the "set time" mode. Use the start button to change each item and use the event button to jump to the next
display item.

Transferring patient data (ID)

The blood pressure monitor must be prepared by transferring patient data (ID) with the help of the HMS CS so that
correct data allocation is possible when reading out.
Further information about this can be found in the HMS CS instructions for use under "accepting
patient ID".
28