Communication Error Mobil-O-Graph; Bluetooth Interface - IEM Mobil-O-Graph Gebrauchsanweisung

Communication error Mobil-O-Graph

Error indication
Code 1 Bluetooth interface of the Mobil-O-Graph
did not start up correctly.
Possible hardware fault.
Code 2 The Bluetooth interface of the Mobil-O-
Graph ® could not be configured correctly.
(Communication problem between the
Mobil-O-Graph
Code 3 The status of the Bluetooth interface of the
Mobil-O-Graph
(Communication problem between the
Mobil-O-Graph
Code 4 The Bluetooth interface of the Mobil-O-
Graph ® is not yet connected to the
Bluetooth dongle.
Code 5 The Bluetooth interface of the Mobil-O-
Graph ® could not connect to the Bluetooth
dongle on the computer.
Code 6 The measurement value memory of the
Mobil-O-Graph
®

Bluetooth interface

Possible cause
®
® and Bluetooth module.)
® could not be determined.
® and Bluetooth module.)
® does contain any blood
Remedy
Send the device to your specialist supplier
or directly to IEM GmbH for checking.
Try it again.
If the error persists, send the device to your
specialist supplier or directly to IEM GmbH
for checking.
Try it again.
If the error persists, send the device to your
specialist supplier or directly to IEM GmbH
for checking.
Try connecting to the device
via Bluetooth ® again.
Try it again.
If the error persists, send the device to your
specialist supplier or directly to IEM GmbH
for checking.
After taking further measurements, these
are sent.
Troubleshooting
EN
51