Buttons - IEM Mobil-O-Graph Gebrauchsanweisung

Product description

Buttons

All buttons are located in the front casing of the blood pressure monitor (see Fig. 1)).
ON/OFF The ON/OFF button turns the blood pressure monitor on and off. To avoid accidental switching
on or off, the button only reacts after 2 seconds.
You can also prematurely terminate the measuring process with this button, as well as with
any other button: the pressure in the cuff is then quickly released (also see the section on
warnings).
Note


DAY/NIGHT The awake and sleep phases can be separated during recording with the DAY/NIGHT button,
which is important for statistics and graphic representations. The detailed specification
regarding the implications for the printout can be found in the respective chapters for the
evaluation units.
The detailed specification regarding the implications for the printout can be found in
the HMS CS instructions for use.
In short: The patient is instructed to press the DAY/NIGHT button when going to bed and again
when getting up in the morning. This individually adapts the measurement interval to the
patient and assists you in the analysis of the blood pressure profile. Next to the interval
adjustment, you will find corresponding notes on the printout. If this button is not pressed, the
interval is changed according to the log set.
22
Switch the device on again to continue working.
When the internal memory battery is empty and the external batteries are
replaced, the device starts up in the last used operating state without the
ON/OFF button being pressed.