IEM Mobil-O-Graph Gebrauchsanweisung Seite 106

Product description
Instructions for preparing the blood pressure monitor using the HMS CS can be found in the HMS
CS instructions for use.
After all the previous steps have been taken, the blood pressure monitor can be put into operation. First of all, a
manual measurement is taken by pressing the "START" button. This measurement will make it possible to
determine if the blood pressure monitor is working properly.
If errors occur, check that the monitor and accessories have been correctly set up and installed. If this does not
help you, repeat the setup procedure.
Only after a successful manual measurement can the patient be discharged until the device is removed.
Terminating measurement
During a measurement, the measurement can be terminated with ANY button. The display will then say "-StoP-"
and a beep will sound 5 times. This termination will also be stored in the table of readings under "terminated".
If the measurement is aborted, a new measurement will start after 3 minutes.
Note
Before a 24-hour measurement, you should go through the patient information sheet with the patient.
The information sheet is
Informationsblatt_Mobil-O-Graph_EN_RevD-2.pdf..
32
available at https://www.iem.de/wp-content/uploads/2020_08_04_