Original Accessories/Attachments; Use; Changing/Inserting The Tool/Collet Chuck - Parkside PGS 500 A1 Originalbetriebsanleitung

■ The clamping nut must be tightened before the
machine is put into operation .
■ Under the influence of extreme external electro­
magnetic interference, temporary speed fluctua­
tions may occur .
■ The workpiece being machined must be
clamped if it is not held in place by its own
weight .
■ Never guide the workpiece onto the grinding
tool by hand .
■ Make sure that the grinding tool is fitted
according to the manufacturer's instructions .
■ The dimensions of the grinding tool must be
appropriate for the grinder .
■ Always work only with the intended working
surface of the accessory tool .
■ Firmly clamp the workpiece you are working
on . Never hold a small workpiece in one hand
and the straight grinder in the other while you
are using it . Always hold the straight grinder by
the designated handles .
■ Guide the straight grinder onto the workpiece .
Apply moderate pressure when working and do
not push the accessory tool into the material .

Original accessories/attachments

■ Use only accessories and additional equipment
that are specified in the operating instructions
(technical specifications) and are compatible
with the appliance .
■ Approved accessory tools: Use only corundum
grinding tools with a shaft diameter that corre­
sponds to the installed collet chuck . Observe
the information in the technical specification .
■ 36 │ GB │ MT

Use

Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Loosen the tensioning nut
using the assembly wrench
♦ Remove any tool that may be inserted .
♦ First, push the intended tool through the
tensioning nut before inserting it into the
appropriate collet chuck
shaft .
♦ Press the spindle lock
♦ Push the (6 mm) collet chuck
insert and screw the tensioning nut
the assembly wrench
♦ To use the (3 .2 mm) collet chuck
into the pre­assembled (6 mm) collet chuck
■ Observe the manufacturer's recommendation
for small grinding tools . The maximum permis­
sible protrusion (L0 = length of the shaft
between the collet chuck end and the small
grinding tool) specified by the manufacturer
must not be exceeded when using small grin­
ding tools! If the protrusion (L0) is increased, the
permissible rotation speed must be lowered .
Wherever possible, insert the complete length
of the shaft of the accessory tool into the collet
chuck . Ensure that the clamping length (Lg) is at
least 10 mm .
Only use attachment parts with a maximum
mandrel length of 40 mm .
and hold it down .
from the thread
.
for the tool
and hold it down .
into the thread
tight with
.
, insert it
.
PGS 500 A1