Device-Specific Safety Instructions For Drill Sharpeners - Parkside PBSG 55 A1 Originalbetriebsanleitung

General safety advice
½
Follow the advice on tool lubrication and con-
sumables replacement.
½
Check the condition of the mains lead on your
electrical power tool regularly and have any
damage repaired by a competent specialist.
½
Check the condition of extension leads regular-
ly and replace them if they are damaged.
½
Keep handles and hand grips clean, dry and
free of oil and grease.
15. Pull the mains plug out of the mains
socket.
½
Do this if the electrical power tool is not being
used, before carrying out maintenance tasks
on the electrical power tool and whenever you
are changing inserted tools, e.g. saw blades,
drills or router bits.
16. Make sure that no spanners, keys etc.
are left attached.
½
Check before switching on that all spanners,
keys and setting tools have been removed.
17. Avoid unintentionally starting up the
device.
½
Check that the switch is set to OFF on the de-
vice when the mains plug is inserted into the
mains socket.
18. Using an extension lead for working
outdoors.
½
When working outside, always use an approved
and appropriately labelled extension lead.
19. Remain alert.
½
Watch what you are doing. Proceed with cau-
tion. Do not use electrical power tools if you
cannot concentrate.
20. Check the electrical power tool for
damage.
½
Before the electrical power tool is used, carefully
check the safety equipment and any slightly
damaged parts to see that they are still work-
ing properly.
½
Check that all moving parts on the tool are
working properly, can move freely and are not
damaged. All parts must be correctly attached
and fulfil all the requirements necessary to allow
the electrical power tool to operate properly.
½
Damaged safety equipment and components
must be properly repaired or replaced at a
competent electrical equipment repair centre
8 GB
All manuals and user guides at all-guides.com
½
½
21. CAUTION!
½
22. Have your electrical power tool
½
½
½
½
½
½
unless otherwise indicated in the operating in-
structions.
Damaged switches must be replaced at a
Customer Service Centre.
Never use an electrical power tool that cannot
be switched on and off properly.
The use of inserted tools and accessories other
than those recommended by the manufacturer
could lead to you being injured.
repaired at an electrical equipment
repair specialist.
This electrical power tool complies with the
relevant safety regulations. Repairs may only
be carried out by a specialist electrical repair
centre using original spare parts, otherwise
injury could occur to the user.
Device-specific safety
instructions for drill
sharpeners
Make sure that the device is switched
off before inserting the mains plug
into the socket.
Always pull the mains plug out before
carry out cleaning or maintenance
work. This is to prevent the device starting up
by accident.
The ventilation openings
tor unit must always be kept clear.
Otherwise there is a risk of the device overheating.
When carrying out work on the device
as well as transporting or storing it,
move the ON / OFF switch
"0" position (off) in order to prevent
it switching itself on by accident.
FIRE HAZARD DUE TO FLYNG
SPARKS! Grinding metal will
cause sparks to fly. That is why you
should always make sure that no-one is at risk
from them and that no combustible materials
are located in the proximity of the area of work.
RISK OF INJURY! Use the
ON / OFF switch to switch the grinder off
4
in the event of a power failure or when pulling
10
of the mo-
4
to the