4.4.2
ASSKEA proVisio
system
Note the hints for health risks due to handling of infectious or pathogenic germs in
section 5.
15. Switch off the ASSKEA proVisio
holding the On / Off button (Fig. 2(C)) pressed for 1-2 seconds.
16. Disconnect the power supply unit from the mains supply (100 V to 240 V AC) if
attached, and then remove the device plug from the aspiration device.
17. Remove the suction tube (Fig. 2(G)) from the patient connection (Fig. 15(B)).
18. Dispose of the suction tube properly.
19. Remove the external canister "Bag" and the disposable liner „OneWay" as described in
section 4.3.3 up to and including step 5 and dispose of these.
20. Remove the holder for the external canister „Bag" from the device by grasping it at the
bottom in the middle and pulling it out of the canister fitting over the rack on the
bottom (Fig. 28). Dispose of the holder for the external canister "Bag".
21. Dispose of the adapter for the disposable secretion canister system according to
section 4.3.3.
22. Clean the surface of the device according to section 5.2.1.
23. Store the device in the shipping carton until the next use.
®
M28 secretion aspirator with disposable secretion canister
®
M28 secretion aspirator after the aspiration by
Fig. 28
Page 71 of 84
en