Inserting The Oven - hanseatic 2013C3.334eETsDpHbW Gebrauchsanleitung

28 mm
15
(f) (g)
6. Use the supplied retaining clamps to fix
the hob in place to prevent it from slipping.
Screw the 4 retaining clamps into the
hob from beneath and affix it in the work
surface with the help of gentle hammer
strokes.

Inserting the oven

NOTICE
Risk of damage!
Do not use the oven door handle to
■
lift the entire oven! It is not designed
to bear the weight of the cooker. Use
the carrying handles on the sides.
Do not set the oven down on the edge
■
or corner of the oven door! The glass
panes can be damaged.
The following conditions must be fulfilled:
– The dimensions of the recess must be 600
× 560 × 560 mm (H × W × D).
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with a ventilation cut-out.
– An intermediate shelf is required if a draw-
er is to be installed below the oven.
– Veneers, plastic coverings and adhesives
which are used must be resistant to heat
(100°C).
Fitting and installation
1. Sweep or vacuum out any residual wood
shavings.
2. Slide the oven into the built-in cabinet as
far as possible using the carrying han-
dles, in order that the earthing screw and
the connector jack are both easily acces-
sible for the hob.
3. Insert the hob plug into the socket on the
top of the cooker. The plug is coded. Po-
larity reversal is therefore not possible.
4. Screw the protective earth cable for the
hob firmly to the oven's protective earth
contact point.
5. Ensure that all connections comply with
VDE 0701.
6. Now push the oven back into the built-in
cabinet completely in a centred position.
The mains connection must not be
kinked, pinched or otherwise damaged.
Page EN-33