Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-34
Fitting and installation
(h)
(h)
(h)
7. Screw the accompanying four screws (h)
through the holes in the sides of the oven
and into the metal rails affixed to the sides
of the built-in cabinet.
Getting started
1. Remove all transport safety devices
(cardboard strips, etc.) and all adhesive
strips from the oven.
2. Turn all the cooker's dials to "0".
3. Switch on or screw in the fuses for the
cooker's electrical circuit.
4. Briefly switch on the cooking zones and
oven, and check that they are functioning
properly.
Pre-cleaning the oven
The oven must be pre-cleaned to remove all
grease and oil residues from the manufactur-
ing process, as well as tough dust deposits
left over from storage and transportation. This
not only helps protect your health but also en-
sures delicious cakes and roasts.
1. In order to do so, operate the oven for
approximately 60 minutes at a convec-
tion heat of 250 °C. Leave the oven rack,
baking tray and dripping pan in the oven
when doing so.
2. Let all parts dry completely afterwards.
3. Wash the oven rack, baking tray, dripping
pan and cooking compartment with clean
water. Then dry everything off.
To use the appliance see page EN-16.
To dismantle the cooker
WARNING
Electric shock / fire hazard!
First switch off the circuit breakers or
unscrew the fuses for the cooker's elec-
trical circuit.
1. Remove the four affixing screws behind
(h)
the oven door.
2. Lift the oven up slightly and pull it out until
the plug of the hob is accessible. Do not
pull on the handle of the oven door!
3. Pull the plug for the hob cable from the
socket on the oven and remove the pro-
tective earth cable from the protective
earth contact point.
4. Lift the oven out of the built-in cabinet
– while taking care not to damage the
mains cable.
5. Remove the 4 retaining clips from the
hob.
6. Push the hob upwards and outwards with
care.
Werbung
Inhaltsverzeichnis
