Inserting The Oven - hanseatic 2013C(G)3.334eETsDpHbB Gebrauchsanleitung

Page EN-32 Fitting and installation
L1 – L3: Phase(s)
N: Neutral conductor
PE: Protective conductor (earth
wire)
230 V 1N~ / 50 Hz
L1 to
  
3 4
N to
 
2 5
N
Protective conductor (PE) to
1
L1 PE
Conductor cross-section: 3 x
6 mm
2
400 V 2N~ / 50 Hz
L1 to

3 4
L2 to
 
2 5
L2 N
N to
 
1
L1 PE
Protective conductor (PE) to
Conductor cross-section: 4 x
2.5 mm2
400 V 3N~ / 50 Hz
L1 to , L2 to

3 4
L3
N to

2 5
L2 N
Protective conductor (PE) to
1
L1 PE
Conductor cross-section: 5 x
2.5 mm2

Inserting the oven

NOTICE
Risk of damage!
Do not use the oven door handle to
■
lift the entire oven! It is not designed
to bear the weight of the cooker. Use
the carrying handles on the sides.
Do not set the oven down on the edge
■
or corner of the oven door! The glass
panes can be damaged.
(bridged)
(bridged)
(bridged)
(bridged)
L3 to
, 
(bridged)
The following conditions must be fulfi lled:
– The dimensions of the recess must be 600
× 560 × 560 mm (H × W × D).
– The built-in cabinet can be equipped with
either ledges/rails or an intermediate shelf
with a ventilation cut-out.
– An intermediate shelf is required if a draw-
er is to be installed below the oven.
– Veneers, plastic coverings and adhesives
which are used must be resistant to heat
(100°C).
1. Sweep or vacuum out any residual wood
shavings.
2. Slide the oven into the built-in cabinet as
far as possible using the carrying han-
dles, in order that the earthing screw and
the connector jack are both easily acces-
sible for the hob.
3. Insert the hob plug into the socket on the
top of the cooker. The plug is coded. Po-
larity reversal is therefore not possible.