In The Display Menu - Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung

CUSTOM SENSORS CONFIGURATION
In the bottom part of the Sensor Configuration panel, it is possible to fully customize the
configuration of every analog port of your OceanLink display.
NOTE: this operation still requires you to perform some setting on the display itself (set
the input to "Custom" and select the data instance).
1 Select the display to be programmed from the drop-down list [A].
If more OceanLink displays are on the network, they will all be visible in this list.
2

IN THE DISPLAY MENU

Sensor Config  Choose the port to be configured  Input  Custom
This setup is required on the display to allow the local pin configuration to be
overwritten.
When CUSTOM is selected, the configuration must come from the Tool.
3 Back on the PC Tool, select the input to configure [B].
This selection must match the pin configured as CUSTOM on the display in the step
before.
4 Select the Sensor type from the drop-down list [C].
set the pin configuration to "CUSTOM".
SENSORS CONFIGURATION
A3C0090070000