Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung Seite 41

CONFIGURE A CAN ALARM
FROM NMEA 2000 OR SAE J1939
1. Press the MENU button and select ALARMS > Setup
2. Select CAN and then the NMEA 2000 or SAE J1939 input
3. Choose the alarm to activate and select Active > Yes, the alarm parameters will appear
4. If necessary, enable/disable the buzzer
NMEA 2000 alarms
Engine (PGN 127489)
Check engine
Over temperature
Low oil pressure
Low oil level
Low fuel pressure
Low system voltage
Low coolant level
Water flow
Water in fuel
Charge indicator
Preheat indicator
High boost pressure
Rev limit exceeded
EGR system
Throttle position sensor
Engine emergency stop
Warning level 1
Warning level 2
Power reduction
Maintenance needed
Eng com error
Sub or secondary throttle
Neutral start protect
Engine shutting down
NMEA 2000 alarms
Transmission (PGN 127493)
Transm. Check transmission
Transm. Over temp
Transm. Low oil pressure
Transm. Low oil level
Transm. Sail drive
SAE J1939 alarms
(DM1)
Engine speed
Boost pressure
Exhaust gas temperature
Engine oil pressure
Engine coolant pressure
Engine coolant temp
Engine oil temp
Transmission oil press
Transmission oil temp
Fuel Level
Water in fuel
A3C0090070000
ALARMS