Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung Seite 16

ELECTRICAL DIAGRAMS
CONNECTION TO THE NMEA 2000® NETWORK
Once the installation is complete, you can interface the device
to the NMEA 2000® network through the dedicated socket on
the wiring harness.
Be sure to tighten the M12 connector by screwing it onto its
counterpart in order to preserve its watertightness.
A drop cable is not required unless the total length of the
supplied wiring is not sufficient to reach the NMEA 2000®
backbone. In this case, the total length can be extended using
one of the accessory drop cables.
Note that NMEA 2000® does not allow drop cables longer than
6 meters.
Refer to the NMEA 2000® standard for proper network design.
A3C0090070000