Getting Started - Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung

GETTING STARTED

OPERATION
OceanLink Display 7" TFT is a versatile device. It lets you control all connected engines in a single
monitoring point and at the same time. The engine whose data is displayed is selected during data page
configuration.
PRIORITY OF RECEIVED SIGNALS
If the same data is available from more than one source for the same engine, the received signal priority
is the following:
•
Analog input
•
SAE J1939
•
NMEA 2000
SWITCHING ON AND OFF
The on/off mode depends on the ignition signal on terminal 15 (Engine1 connector, pin 7).
At power up, logo and software version followed by a security message appear when turned on followed by
the last data page viewed before turned off.
You can customize the loading image displayed at power up using the Veratron Configuration Tool.
Contact your veratron dealer for more information.
BUTTON FUNCTIONS
Button Name
MENU
UP
DOWN
ENTER
TOUCH
BUTTON
Function
Briefly press:
•
Open the menu
•
Return to the previous menu
Hold down:
•
From any point to return to the data pages
Briefly press:
•
Scroll pages/options
Pressed simultaneously:
•
Set the display and connected 52 mm gauges brightness
Briefly press:
•
Open a sub-menu
•
Confirm the selection
Hold down:
•
In the MediaBox page to save the selected station radio frequency
Briefly press:
•
View the data page linked to the button
Hold down:
•
Link the button to the displayed data page
GETTING STARTED
A3C0090070000