Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung Seite 30

SET THE DAY/NIGHT MODE
To set the desired mode, act on pin 10 of the MX150 connector as follows:
To set the mode...
day
night
CHANGE THE BRIGHTNESS OF THE DISPLAY
There's a shortcut to change the brightness of the display. The change affects the set day or night mode.
•
Press and hold the buttons UP and DOWN until the menu Illumination appears.
•
Change the illumination brightness with the buttons UP and DOWN.
•
Confirm and close the menu with ENTER
•
To exit the menu without saving the changes press the MENU
SAE J1939 GATEWAY
The OceanLink display is equipped with two independent SAE J1939 ports to connect your CAN engines to
the display and read the digital data coming from them.
Make sure to properly setup the J1939 gateway so that all the engine data are transmitted on NMEA 2000
with the correct instance.
Then...
move the pin switch to GND/OPEN.
move the pin switch to BATTERY PLUS.
SYSTEM SETTINGS
A3C0090070000