Input Selection - Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung

1.

INPUT SELECTION

Once in the SENSOR CONFIG menu, select
"Engine 1 connector" or "Engine 2
connector" depending on which connector
the sensor is electrically connected to.
Then select the analogue input (on that
connector) where the sensor output is wired.
2. CHOOSE THE SENSOR TYPE
Select what kind of sensor is connected to
that input.
See the menu diagram for the complete list
of supported sensors.
Select "Custom" for importing the complete
input configuration from the PC Veratron
Configuration Tool.
3. CONFIGURE THE NMEA 2000 OUTPUT
The measured value for the configured
analog sensor is also transmitted over NMEA
2000, so the OceanLink display will act as a
source for that data.
Use the menu item "Show Value As" to
modify the NMEA 2000 instance for that
sensor.
If a configuration conflict is detected in the
setup (like when two sensors with same
instance are configured on different analog
ports), the display will show a warning.
CALIBRATE THE SENSOR
4.
Every sensor type has a standard calibration
(see "Default supported calibrations").
Veratron sensors are by default supported.
It is however possible, for some sensors, to
calibrate the sensor through a calibration
wizard (see next chapters).
Every sensor type can be always calibrated
via the PC-based veratron Configuration
Tool (see "Sensor calibration with Veratron
Configuration Tool").
SENSORS CONFIGURATION
A3C0090070000