Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Setting
EasyLink >
EasyLink connector
1 / EasyLink
connector 2
J1939 >
Connector1 /
Connector 2
Reset >
Reset factory
Reset >
Reset Trip time
Reset >
Reset Trip Distance
Reset >
Reset Trip Fuel
Reset >
Reset MediaBox
Demo mode
UNITS
Setting
Distance
Boat speed
Wind speed
Depth
Pressure
Fuel
Fuel flow
Temperature
Description
Which engine and tanks are to
be displayed on the EasyLink
gauges.
Configuration for the SAE
J1939 to NMEA 2000 gateway.
All the data received from the
J1939 bus will be sent on
NMEA 2000 with the instance
specified here.
Reset the display to factory
default.
Only available with a MediaBox
device connected.
The MediaBox settings are
reset to factory default.
Demo mode activation.
Simulated data are NOT sent
on NMEA 2000.
Note: the demo mode will
remain active after the unit is
restarted.
Metric
Imperial
km
mi
km/h
mph
km/h
kn
m
ft
bar
psi
L
gal
L/h
gph
°C
°F
Possible values / commands
•
Show engine data from: Engine 1–4
•
Show fuel from: Tank 1–4
•
Show fresh water from: Tank 1–4
•
Show waste water from: Tank 1–4
Send to NMEA 2000 As:
•
Auto: the display keeps the J1939 engine
identifier also for the NMEA 2000 network.
•
Engine 1–4
•
Yes
•
No
•
Yes
•
No
•
Yes
•
No
•
Yes
•
No
•
Yes
•
No
•
On: display data are simulated. The simulation is
sent on EasyLink satellites too.
•
Off: demo mode is off.
Nautical
Custom
nm
km, mi, nm
kn
km/h, mph, kn
kn
km/h, kn, m/s, bft
ft
m, ft
psi
bar, psi, kPa
gal
L, gal
gph
L/h, gph
°F
°C, °F
SYSTEM SETTINGS
A3C0090070000
Werbung
Inhaltsverzeichnis
Fehlerbehebung
