Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung Seite 18

CALIBRATION WIZARD
The Calibration wizard appears when first turned on after reset and every time turned on
until sensors are calibrated.
The display prompts you to configure your sensors.
Choose Yes, to open menu SENSOR CONFIG.
Choose No, to display the first default data page and configure the sensors later.
STARTUP CHECKLIST
Following are the steps for initial configuration:
1. Connect any sensors to analog inputs.
2. When turned on, read the security message, then select Yes to open the menu
SENSOR CONFIG and configure sensors (see "Sensor configuration").
3. Set up general device operations (see "System settings").
4. Add/remove data pages selecting the best layout and data to be viewed (see "Data
page configuration").
5. If a page layout with bar graphs is used, customize the minimum and maximum
intervals (Bar graph settings, see "System settings").
6. Enable/disable local, NMEA 2000 and J1939 alarms (see "Alarm management").
UPLOAD A CUSTOM SPLASH LOGO
A custom splash logo can be loaded from a PC using the veratron Configuration Tool.
For more information, please refer to the veratron Configuration Tool user manual or
contact your veratron reseller.
GETTING STARTED
A3C0090070000