Veratron OCEANLINK 7 MARINE DISPLAY Bedienungsanleitung Seite 28

OPERATING THE SYSTEM CONFIG MENU
NOTE: the underlined value/command is the factory default one.
Setting
Display >
Illumination Day
Display >
Illumination Night
Display >
Bargraph settings
Display >
Illumination mode
Display > Auto
Day/Night Switch
Units
Damping >
Wind damping/
Heading damping
Clock >
Clock format
Clock >
Clock offset
Description
Brightness of the display for the
day mode.
NOTE: this setup affects all the
EasyLink gauges too.
Brightness of the display for the
night mode.
NOTE: this setup affects all the
EasyLink gauges too.
Bar graphs minimum and
maximum setup.
Color palette and brightness
profile selection.
Enable the built-in light sensor
to automatically change
between day and night mode
and sets at which level of
brightness the display should
toggle.
NOTE: This is only possible if
the Illumination input (term.
58) is disabled in the sensor
configurations.
Unit of measure for the
displayed data.
Damping for wind and heading
displayed data.
Clock format.
Time zone setup.
Possible values / commands
0–7, Auto
0-7
•
Boost press: 0–13 bar (default = 0–1)
•
Engine temp 0–300 °C (default = 0–200)
•
Battery voltage 8–32 V (default = 10–16)
• Fuel flow 0–800 l/h (default = 0–150)
• Blue day: blue dials, white numbers, Illumination:7
• Blue night: blue dials, red numbers, Illumination:2
•
Amber day: amber dials, white numbers,
Illumination:7
•
Amber night: amber dials, red numbers,
Illumination:2
•
OFF
•
Bright
•
Medium
•
Dark
•
Metric
•
Imperial
•
Nautical
•
Custom
•
No
•
Low
• Medium
•
High
•
12 h
•
24 h
From -12h to +12 h (0 h)
SYSTEM SETTINGS
A3C0090070000