Stand-Alone Mode; Master/Slave Operation - EuroLite LED Twin Scan Bar Bedienungsanleitung

Stand-alone mode

Automatic mode
In automatic mode, 16 different show programs are available that run at an adjustable speed.
1 Call up the operating mode AUTO (automatic mode) in the menu.
2 For program selection navigate to menu item Program using the UP and DOWN buttons and confirm
with ENTER. Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
3 Under Color 1 / 2 you can select the desired color and under Gobo 1 / 2 the desired motif. Confirm with
ENTER.
Sound control
Via the integrated microphone the unit can perfectly reproduce the 16 show programs to the rhythm of the
music (sufficient bass provided).
1 Call operating mode SOUND (sound control) in the menu.
2 For program selection navigate to menu item Program using the UP and DOWN buttons and confirm
with ENTER. Use UP and DOWN to select the number of the desired program. Confirm with ENTER.
3 Under Color 1 / 2 you can select the desired color and under Gobo 1 / 2 the desired motif. Confirm with
ENTER.
Manual mode
The Manual mode allows effects to be individually adjusted.
1 Call operating mode Manual in the menu.
2 Navigate to the desired effect.
3 In the Pan and Tilt menu items, you can set the pan and tilt angles of the scanner mirrors. Under Color
you can select the desired color and under Gobo the desired pattern. In the Dimmer menu item you can
define the brightness and in the last menu item Strobe the strobe effect. Confirm with ENTER.

Master/slave operation

Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
1 Configure all slave units before connecting the master unit. For this, call up operating mode SLAVE and
M/slave in the menu and confirm with ENTER.
2 Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the
DMX output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Make sure the master unit is the first in the chain. Do not connect a DMX controller
to the DMX input of the master unit.
3 Select the desired show program or color mode at the master unit. The interconnected devices will now
operate synchronously.
34/44 00141601.DOCX, Version 1.0