Operation With The Ir Remote Control - EuroLite LED Twin Scan Bar Bedienungsanleitung

Operation with the IR remote control

The IR remote control allows convenient control of the integrated show programs in automatic mode or
sound-controlled mode. The IR remote control will only work in stand-alone mode, it will not work in DMX or
slave mode. Press the buttons repeatedly to switch between the programs. The display indicates the current
setting. When actuating a button, always hold the remote control in the direction of the sensor at the control
unit's front or rear. A direct line of sight between the remote control and the sensor is required. The remote
control can be activated/deactivated in the system settings.
Battery
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote control
is not possible.
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the right
and at the same time remove the battery support. For operation, one 3 V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
Button
On/off
Switch through automatic programs AP1-AP16
Switch through sound-controlled programs SP1-SP16
Pause / play
Set running speed for automatic- and sound mode
-
No function
No function
No function
No function
No function
35/44
Function
00141601.DOCX, Version 1.0