Stand-Alone Mode; Dmx Operation - EuroLite LED TSL-1500 Scan Bedienungsanleitung

Stand-alone mode

Funktion
DMX Address
Adjusts the DMX address.
DMX Channel Selects the DMX channel mode.
Running Mode Selects the desired operating mode: DMX / Auto / Sound / Manual / Test
Programs Select the desired internal program (1 ~ 9).
Manual control
Sets operating parameters manually.
Test Checks each parameter (pan, tilt, dimmer etc.) via an automatic run.
Sets several operating parameters:
Pan Invert
Tilt Invert
Display Invert
Backlight
Settings
Sensitivity
DMX Fail
Calibration
Factory Reset
Reset Motor
System Info You can read out several operating parameters.

DMX operation

Setting the DMX starting address
For operation with a controller with DMX512 protocol, the device is equipped with 13 control channels. To be
able to operate the device with a DMX controller, the DMX starting address must be set. The starting
address depends upon which DMX controller is being used. Please refer to the controller's documentation.
1 Press the UP or DOWN button so many times until DMX Address is indicated on the display. Confirm
with the ENTER button.
2 Now the display calls up the menu item for the DMX starting address: 001.
3 Use the buttons UP and DOWN to set the address. Confirm with the ENTER button.
4 Press the UP or DOWN button so many times until DMX Channel is indicated on the display. Confirm
with the ENTER button.
5 The display indicates 13 CH (13 DMX channels). Confirm with the ENTER button
6 The display will light up continuously when DMX signals are being received.
Note: Please make sure that you do not have any overlapping channels in order to control each device
correctly and independently from any other fixture on the DMX chain. If several devices are addressed to the
same address, they will work synchronically.
Erklärung
Reverses the PAN movement.
Reverses the TILT movement.
You can flip the display by 180° for a better view when the fixture is
suspended.
ON: display always on; OFF: shuts off the display after 30 seconds
Adjusts the microphone sensitivity between 0 % and 100 %.
You can hold or "clear" (OFF) the DMX value if there is no DMX
signal.
Service only.
Resets all parameters to factory default.
Resets the motors.
27/32 Version 1.0