Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
19
20
INSTALLATION
Overhead rigging
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
1
2
3
Screw one coupler via an M10 screw and self-locking nut onto the Omega bracket. Insert the quick-lock
fasteners of the Omega bracket into the respective holes. Tighten the quick-lock fasteners fully
clockwise.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. An
appropriate eyelet is installed on the device for fixation of the safety bond. Fasten the safety bond in such
a way that, in the event of a fall, the maximum drop distance of the device will not exceed 20 cm.
5
After installation, the device requires inspections periodically to prevent the possibility of rot, deformation
and looseness.
19
Quick-lock fastener
20
Omega bracket
21
Stand sleeve with fixation screw
21
28/44
(1) Coupler
(2) Quick-lock fastener
(3) Omega bracket
(4) Safety bond
00141601.DOCX, Version 1.0
Werbung
Inhaltsverzeichnis
