Trimming The Helicopter - Reely Bigfox Bedienungsanleitung

17. Trimming the helicopter

When the two joysticks on the transmitter are in the middle position, the helicopter should barely change its position
when hovering.
However, if the helicopter tends to constantly fly in one direction or turn on the spot, this can be corrected with the trim.
But before you readjust the trim, you should first calibrate the position sensors (see Figure 15).
Every time a trim button is pushed, the trim is adjusted by one step and the adjustment is confirmed by a
short beep. When the button is pressed and held, the transmitter emits a quick sequence of beeps, and
thus indicates the step-by-step adjustment of the trim. Up to five additional dashes are gradually displayed
next to the corresponding trim display.
Once the trim's end position has been reached, the transmitter will stop beeping. The trim's centre position
is indicated acoustically by a longer beep. The digital trim setting is not saved and is always in the middle
position when the transmitter is switched on.
Pitch trimming
Since the helicopter has active altitude stabilisation, pitch trimming is not required. For this reason, the trim buttons
that are not required can be used for automatic take-off and landing (see Figure 16).
Tail trimming
If the helicopter fuselage nose tends to turn to the right, press the left trim button for the tail function (see also Figure
1, no. 10). Keep the button pushed until the model no longer tends to turn to the right (see light arrows in 17).
If the fuselage nose turns to the left, press the right trim button for the tail function (see dark arrows in Figure 17).
58
Figure 17