Transmitter Controls - Reely Bigfox Bedienungsanleitung

8. Transmitter controls

1 Transmitter antenna
2 LC display
3 Push-button for hover adjustment
4 Joystick for bob and roll functions*
5 Trim button for the roll function
6 Trim buttons for the bob function
7 On/off switch
* The two joysticks are automatically held in the middle position by spring force. For further information on the steering
functions, see the section "General information on controlling model helicopters".
Switching on the transmitter automatically activates control mode II. This mode enables you to raise and
lower the helicopter (pitch function) with the left joystick and fly the helicopter forwards and backwards (bob
function) with the right joystick.
Further explanations in these operating instructions always refer to control mode II. Control mode I can
be activated by swapping the bob and pitch functions on the transmitter. More details can be found in the
section "Changing the joystick assignment".
Figure 1
8 Push-button for the take-off function
9 Push-button for the landing and stop function
10 Trim buttons for the tail function
11 Joystick for the pitch and tail function*
12 LED indicator
13 Push-button for beginner/expert mode
43