Trimming; Trim Buttons; Trimming In-Flight - Reely TWINS Bedienungsanleitung

3. Check the trim settings shortly after take-off. Details of the trim settings can be found in section 13. Trimming.
4. Land the model as soon as the timer starts to beep
5. Press the motor stop button
- Leave the remote control switched on.
6. Bring the model into shade.
7. Disconnect the flight battery and let it cool down to room temperature.
8. Turn off the remote control.
Motors, flight controller and flight battery may heat up when the model is in use. For this reason,
take a break of 5 to 10 minutes before starting a new flight.

13. Trimming

If the model tends to drift in one direction, use the trim button to adjust the neutral position of the corresponding rudder.

13.1 Trim buttons

The trim button on the remote control (R5-R8) allows you to trim the controls during a flight. The most recent trim
setting is automatically saved and retrieved when the remote control is switched back on.
Each trim input is confirmed by a beep on the remote control.

13.2 Trimming in-flight

T1
13.2.1 Rudder
The rudder is configured via the two motors. Before configuring the trim settings, set the motors to 50% of their
maximum power.
If the model drifts to the left: Press the trim button for the rudder (right) (R7) repeatedly until the model flies in a
straight line.
If the model drifts to the right: Press the trim button for the rudder (left) (R8) repeatedly until the model flies in a
straight line.
13.2.2 Elevator
Set the elevator trim so that the model ascends at a flat angle at full motor power and flies at a constant height when
the motors are switched off.
Centre of gravity: Changing the position of the flight battery changes the model's centre of gravity.
This should be noted when trimming the controls.
F3
(R11) after landing.
.
45