mectron starlight pro Gebrauchs- Und Wartungsanleitung Seite 13

WARNING: Cleaning, disinfection and sterilisation of new or repaired products.
Before treatment, all new or repaired products should be cleaned and disinfected and, if
suitable for this treatment, autoclave sterilised following the instructions provided in
on page 19 strictly.
WARNING: Infection control.
In order to ensure maximum safety for both the patient and the operator, clean, disinfect
and sterilise the optical fibre and the optical protection before each treatment. Follow the
instructions provided in
WARNING: Use only original Mectron accessories and spare parts.
WARNING: Checking the condition of the device before treatment.
Before each treatment always check that the equipment is in proper working order and that
the accessories are efficient. Do not carry out the treatment if any problems are encountered
in operating the equipment. If the problems concern the equipment contact an authorised
technical service centre.
WARNING: Risk of explosions.
The equipment cannot operate in environments where there are saturated atmospheres of
flammable gases (anaesthetic mixtures, oxygen, etc.).
WARNING: Do not use the charging unit to recharge other types of batteries or other
equipment with rechargeable batteries.
CAUTION: Recharge the battery only with the Mectron charging unit (
8 - Ref. A). Do not attempt to recharge the battery using a generic battery charger. This
entails a risk of explosion and fire.
Risk Group 2
CAUTION. Possibly hazardous optical
radiation emitted from this product.
Do not stare at operating lamp. May
be harmful to the eye
Product tested against IEC62471
Figure 1 – Photobiological safety
Chapter 7 on page 19 .
INtrODUCtION
Chapter 7
Figure 4 at page
5