Connecting The Mains Plug; Installation - hanseatic WQP12-7713I Gebrauchsanleitung

Page EN-24 Installation, connection and initial commissioning
the dishwasher, otherwise this can
damage the appliance.
If the water pressure is higher than
■
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous fl ow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
paired by a specialist ("Service" see
page EN-32).
Do not use old or previously installed
■
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾ inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping
from the connection. Then close the valve
again.
All manuals and user guides at all-guides.com

Connecting the mains plug

Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
■
Fire hazard!
■
Requirements:
– A professional must install an earthed pow-
– The socket must be installed in such a way
– Do not use a multi-socket extension cable,
– We recommend using a pulse-sensitive re-
• Connect the mains plug to the socket.

Installation

Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
■
WARNING!
Prior to connecting the dishwasher,
ensure that you have page EN-6 tak-
en note of all the safety instructions
and adhered to them.
Never use multi-socket adapters,
multi-socket strips, travel adapters or
the like.
er socket with its own fuse of a sufficient
size (220 - 240 V~ / 50 Hz / 10 A).
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
multi-socket plug, travel adapter, extension
cable or similar.
sidual current device (RCD).
NOTICE
Use the screws supplied (i) or screws
of the same length.