Putting Into Operation - LORCH ML 1500 Betriebsanleitung

MIG/MAG welding torches ML/MW GRIP

6 Putting into operation

6.1 Equipping and connecting the cable assembly
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of
maintenance, servicing, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
NOTICE
• Please take note of the following instructions:
 3 Product description on page EN-7
• The system may only be installed and put into operation by qualified
personnel (in Germany see TRBS 1203).
Select the wire type and suitable wire guide for your application.
1 Lay the cable assembly out straight then push the cut-to-length wire guide
(liner or PA liner) through the torch neck from the central connector.
2 Tightly screw on the nut with the switch key wrench.
3 Cut off the liner flush with the torch neck.
4 Make sure that the cutting edge is free of burrs.
6 Putting into operation
EN - 11