Assembling Drawer; Installing Console-To-Shelf - ConMed D4001 Benutzerhandbuch

ENGLISH/INSTRUCTIONS FOR USE
3.5

Assembling Drawer

1. Install drawer to the bottom of shelf using four (4) 6-32 x ¼" screws and tighten using the 4 mm hex key.
2. Push in drawer.
3.6

Installing Console-to-Shelf

NOTE: Standoffs can be removed from the shelf if they interfere with placement of equipment.
1. Place each piece of equipment on an individual shelf.
2. Use the shelf standoffs to position and attach the equipment to the shelf, where applicable.
3. Remove thumb screws from standoffs.
4. Place the holes in the bottom edge of the back of the equipment over the standoffs.
5. Replace the thumb screws.
Figure 4 – Drawer Assembly
Figure 5 – Console-To-Shelf Installation
6