Inhaltsverzeichnis
Werbung
ENGLISH/INSTRUCTIONS FOR USE
3.7
Installing Handle with Cord Hooks
1. Slide metal brackets on handle into back extrusion of the Cart and firmly secure at the desired height.
a. Ensure handle is level.
b. Tighten all 4 screws on the cart handle with the provided 4mm Allen wrench. See Figure 6 below.
2. Insert extrusion caps into top of extrusion rails by pressing into place. See Figure 7 below.
Figure 6 – Handle Assembly
Figure 7 – Extrusion Cap Placement
7
Werbung
Inhaltsverzeichnis
