Switching On And Off; General Working Instructions; Use As A Grass Trimmer; Use As A Hedge Trimmer - Parkside PGSA 4 A2 Originalbetriebsanleitung

GB IE
Remove the blade:
3. Press the release button (9) on the
cutting head (1) and remove the entire
blade.

Switching on and off

1. Remove the blade guard (11/13) before
switching the unit on.
2. Insert the safety key (7) into the device.
3. To switch on, hold the switch lock (3)
depressed and operate the on/off
switch (8). Then release the switch lock.
The equipment runs at top speed.
4. In order to switch off, let go of the on/
off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the blades or slow them
down before the moving parts
have come to a standstill.

General working instructions

While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
• Check the grass and bush trimmer blades
for obvious defects such as loose, worn or
damaged parts. Check that the screws are
seated fi rmly in the blade block.
• Remove the power supply unit before
working with the equipment. Do not use
extension cables.
14
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on unit
maintenance and cleaning.

Use as a grass trimmer

• Grass is best cut when dry and not too
long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° in both direc-
tions.
The cutter head (1) features 3 positions:
+90°, 0°, -90°.
1. Operate the unlocking mechanism (4)
and turn the cutter head (1) into the
desired position.
2. Release the unlocking mechanism (4) so
that the cutter head (1) locks into place.

Use as a hedge trimmer

• Move the unit forward evenly.
• The double-sided cutting heads enable
cutting in both directions or by swing-
ing the unit from side to side.

Cleaning/Maintenance

Leave any work not covered
in this manual to our Service
Centre. Only use original
parts. There is a risk of injury!
Ensure that the safety key (
removed before all tasks.
7) is