Charging Process; Operation; Insert/Replace The Blade - Parkside PGSA 4 A2 Originalbetriebsanleitung

Charging process

Do not expose the battery to
extreme conditions such as
heat and impact. There is a risk of in-
jury from leaking electrolyte solution!
In case of contact, rinse with water or
neutraliser and consult a doctor if
contact has occurred with eyes etc.
Charge the battery only in
dry areas.
Do not switch on the device while
charging it. There is a risk of injury
from electric shock.
The rechargeable battery reaches
its full capacity only after it was
charged several times.
The safety key must be inserted dur-
ing the charging process.
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable safety
information as well as the regulations and
directions for environmental protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
Attention: Use a USB-C standard
power adapter with a supply/
charge voltage of 5 V and a charge cur-
rent of below 2200 mA. For charging,
the product may only be connected to a
device with one of the following sym-
.
bols: or
III
1. Insert the safety key (7).
2. Connect the charging cable (14)
to a power supply unit.
3. Connect the charger cable plug
(15) with the charger socket on
the tool (6).
4. Connect the power supply unit to
a socket.
The charging indicator (2) lights up:
Red: Equipment charging.
Green: Charging fi nished.
The duration of the charging time
depends on the technical data of
the power adapter.
5. After the recharging process is
completed, fi rst unplug the charg-
er from the wall outlet, and then
remove the charger cable plug
(15) from the tool.

Operation

Keep to noise abatement regulations
and other by-laws.

Insert/replace the blade

Before inserting or replacing
the blades, make sure that
the appliance is switched
off and the safety key (7) is
pulled in order to prevent
hazards and injuries.
Insert the blade
1. Put the grass cutting blade (10) or the
bush cutting blade (12) onto the plug-in
connector (16) on the bottom side of the
cutter head (1).
2. Press the blade into the direction of the
cutter head (1). It locks into place audibly.
GB IE
13