Herunterladen Inhalt Inhalt Diese Seite drucken

Switching On And Off; Checking The Battery Charge Level; Working With The Hedge Trimmer; Cutting Techniques - Parkside PHSA 12 A1 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PHSA 12 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
GB
IE
functional before each use.
The On/Off switch and the
safety switch must not be
held closed. They must switch
off the motor when on is re-
leased. Should a switch be
damaged, stop working with
the equipment. Ensure that the
mains voltage value matches
the label on the equipment.
Reduce the risk of injuries and
accidents by wearing person-
al protection equipment and
ensuring that the unit is fully
functional.
Note noise protection and local
specifications.

Switching On and Off

Ensure that you are standing in a
firm position with both hands grip-
ping the hedge trimmer away from
the body. Ensure that the trimmer
is in contact with no other objects
before switching on.
Removing the blade guard:
1. Press the blade guard (
points marked
Turning on:
2. Check that the battery (9) is in (Observe
the separate operating instructions for
the rechargeable battery and charger).
3. Press the safety switch (3) at the front
handle (4).
4. Press the On/Off switch (8). The hedge
trimmer will run at top speed.
Turning off:
5. Release the safety switch (3) or the
On/Off switch s (8).
26
10) at the
and remove it.
press
Checking the battery charge
level
The battery charge indicator (
ises the state of charge of the battery (
while the device is operating.
3 LEDs are on (red-yellow-green)
: Battery charged
2 LEDs are on (red-yellow):
Battery partially charged
1 LED is on (red):
Battery needs to be charged
Only charge the battery (
when the red LED on the charge
level indicator is on.
Working with the Hedge
Trimmer
During cutting work, ensure that no
contact is made with objects, e.g.
such as wire fencing or main plant
stems. This may result in damage to
the cutter bar.
If the blades become jammed with solid
objects, turn the device off immediately
and remove the rechargeable battery.
Only then should you remove the object.
Avoid overstraining the equipment dur-
ing work.

Cutting Techniques

Cut thick branches beforehand using a
branch clippers.
The double-sided cutter bar enables cut-
ting in both directions or, with a swing-
ing action, from one side to the other.
In case of vertical cutting, move the
hedge trimmer uniformly forward or up
and down in an arc movement.
6) signal-
9)
9)

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis