Insert/Replace The Blade; Switching On And Off; General Working Instructions; Use As A Grass Trimmer - Parkside PGSA 4 A2 Originalbetriebsanleitung

GB IE

Insert/replace the blade

Before inserting or replacing
the blades, make sure that
the appliance is switched
off and the safety key (7) is
pulled in order to prevent
hazards and injuries.
Insert the blade
1. Put the grass cutting blade (10) or the
bush cutting blade (12) onto the plug-in
connector (16) on the bottom side of the
cutter head (1).
2. Press the blade into the direction of the
cutter head (1). It locks into place audibly.
Remove the blade:
3. Press the release buttons (9) on the
cutter head (1) and remove the entire
blade.

Switching on and off

1. Remove the blade guard (11/13) before
switching the unit on.
2. Insert the safety key (7) into the device.
3. To switch on, hold the switch lock (3)
depressed and operate the on/off
switch (8). Then release the switch lock.
The equipment runs at top speed.
4. In order to switch off, let go of the on/
off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the blades or slow them
down before the moving parts
have come to a standstill.
32

General working instructions

While trimming, take care that there
are no objects such as wire, metal
parts, stones etc. come into contact
with the blades. This can lead to
cutting head damage. If the blades
become blocked by solid objects,
switch off the unit at once.
• Check the grass and bush trimmer
blades for obvious defects such as loose,
worn or damaged parts. Check that the
screws are seated firmly in the blade
block.
• Remove the power supply unit (
before working with the equipment. Do
not use extension cables. The power
supply unit is to be used only in en-
closed spaces.
• Only use sharp blades to achieve a
good cutting performance and pre-
serve the battery.
• Do not work the unit so hard that it
comes to a standstill.
• Pay attention to the instructions on unit
maintenance and cleaning.

Use as a grass trimmer

• Grass is best cut when dry and not too
long.
Adjusting the working angle
For a comfortable edge cut, the cutter head
(1) can be rotated by 90° in both direc-
tions.
The cutter head (1) features 3 positions:
+90°, 0°, -90°.
1. Operate the unlocking mechanism (4)
and turn the cutter head (1) into the
desired position.
14)