High Temperature-Risk Of Burns - Gastroback Design Tee Automat Advanced Plus Bedienungsanleitung

• In various foreign countries, the specifications for power supplies are
subject to incompatible norms. Therefore, it is possible that power sup-
plies in foreign countries do not meet the requirements for safe opera-
tion of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible.
• Do not use any desk top multi socket outlet, external timer, remote
control systems or extension cord. The power outlet must always be
easily accessible so that it would be possible to unplug the appliance
immediately in case of any malfunction or danger.
• The pins of the power plug and the power connectors in the power
base and bottom of the kettle must be smooth and clean without dis-
colourations. Keep the power connectors (kettle, power base, and
power cord) always completely dry. Do not poke in the power con-
nectors. Do not attempt to operate the appliance with the power
connectors damaged or polluted in any way to avoid risk of over-
heating, fire, and electric shock.
• Always unwind the power cord completely for operation to avo-
id hazard of overheating, fire and electric shock. Always handle
power cords with care. Do not place the appliance on a power
cord. Power cords may never be knotted, twisted, pulled, strained, or
squeezed. Do not let the plug or power cord hang over the edge of
the table or counter. The power cord may never touch hot surfaces,
sharp edges, or any moving parts. Ensure that no one will pull the
appliance by the power cord. Take care not to entangle in the power
cord. Always grasp the plug to disconnect the power cord. Do not
touch the appliance or power plug with wet hands, while the appli-
ance is connected to the power supply.
• Do not place or immerse the power base, kettle or power cord in water
or any other liquid. DO NOT spill or drip any liquids on the power
base or the power cord or on the exterior of the kettle to avoid risk of
fire and electric shock. If liquids run out or are spilled onto the exterior
of the power base or kettle, do not touch the appliance but immediate-
ly unplug the appliance. Always wipe off spilled liquids immediately. If
in doubt, check the kettle for leakage, before operating the appliance
EN
70
again. When parts of the appliance are leaking during operation and/
or liquids accumulate under the power base or run down on the exterior
of the appliance or any part of it, immediately unplug the appliance.
Refer to the instructions in chapter 'Solving Problems'.
• Do not place the power base or kettle in an automatic dishwasher.
Do not place the power base on a metal surface, or in a large bowl
or tray for operation. If water is spilled or runs out and accumu-
lates, there would be severe risk of short-cut, electric shock, and
fire. The kettle should NOT be filled, while standing on its power
base. Always remove the kettle from the power base. Remove the lid
or filter system for filling.
HIGH TEMPERATURE—RISK OF BURNS
WARNING
The Glass Tea Kettle is equipped with electric heating
–
elements for heating up drinking water to the boil. Thus, the appliance
could cause severe scalds, burns and damage, when used improperly.
• Always hold the kettle level when it is filled, to avoid spilling. The
appliance and the contents will be hot even for some time after ope-
ration. Always leave the appliance cool down, before filling again,
cleaning or storing the appliance.
• Even with the lid closed properly, hot steam and splashes of hot water
could escape during operation. Do not hold your face or other parts of
your body over or directly near the appliance during operation and while
the appliance is still hot to avoid scalds due to steam and splashes.
• Even the exterior of the kettle and filter system could get very hot during
operation and thereafter. Only touch the appliance and its parts and
accessories at the operating elements and the handles, when they could
be hot. Beware of hot steam and condensate, when opening the lid,
removing the filter system and/or pouring. Before pouring, wait until the
water stops boiling and then pour carefully to avoid spilling.
• Keep the lid closed during operation and when the water is boiling
or still very hot, to avoid scalding and damage caused by hot water
and hot steam. Before pouring, ensure that the lid and lid ring are
installed properly and stably and will not fall down.
EN
71